The HDLP-A Hanger (PREVIOUSLY CALLED THE CRCH-X) has been designed as a low profile ceiling hanger and is used where floor to ceiling heights are critical. It uses the same spring element as the 30-X and HDQF-X Hanger, and therefore has the same properties.

View Datasheet

Mason UK offers a complete soundmasking design and installation service. Our system is highly flexible and can be used for many applications from a small office to an entire office block. Click the link for more information.

The MFS-AJ is a jack specially built for attachment to joists and its used as part of a lightweight acoustic floating floor system. Click below for more

MFS-AJ datasheet View Datasheet

The MFS-AF is an acoustic floating floor jack specifically built for lightweight floors. The ability to adjust the height gives it an advantage over the standard MFS when placing jacks on floors that aren't level. Click below for more.

MFS-AF datasheet View Datasheet

Mason Adjustable Sliding Guides(ASG) are pipe guides that can be installed in any orientation. They come is a range of standard sizes to suit pipes from 20mm to 300mm in diameter. Larger Guides are available on request.

Adjustable Sliding Guide Bulletin View Datasheet

The HDSM joist hanger has been created to bolt directly to the side of a joist. A thread can be run down to attach to a suspended ceiling frame, an eyebolt or other attachments.

HDSM Datasheet View Datasheet

The HDLP-A Hanger (PREVIOUSLY CALLED CRCH) has been designed as a low profile ceiling hanger and is used where floor to ceiling heights are critical. It uses the same rubber element as the HD-A and HDQF-A Hanger.

HDLP Low Profile Hanger View Datasheet

HDQF-X quick fit spring ceiling hanger. Our HDQF-X hanger has been designed to aid the quick and easy installation of suspended acoustic ceilings.

HDQF Spring PDF View Datasheet HDQF Spring Installation Instructions View Datasheet

HDQF DWG View CAD File

Quick fit ceiling hangers are made from high quality low dynamic stiffness (LDS) natural rubber. This hanger has been designed to aid the contractor with a quick installation of suspended acoustic ceilings which use a metal grid system.

HDQF-A - Acoustic Hanger PDF View Datasheet

HDQF DWG View CAD File

The AFA is an acoustical furring attachment for use with metal or wood stud walling. The AFA clamps the top hat section of the metal framing system to which boards are then attached

AFA Data Sheet View Datasheet